Equipment Operation
6-13
The cockpit cover installs over the windshield and snaps to the deck.
To install the cockpit cover, note that at the bow end of the cover there
is a seam on the inside which separates the port and starboard sides.
Align this seam with the center snap below the windshield. Complete
snapping the canvas to the outside and then down each gunnel to
admidships.
This type of canuvas cover requires several cockpit poles. Their purpose
is to keep the canvas tight and water out of the interior. Notice on the
underside of the cover there are areas of reinforced canvas material.
These are for the cockpit cover poles. Each pole is adjustable by
opening it to the desired length and tightening the thumb screw. You
may fi nd it helpful to mark the poles so you can install them in the
same location each time.
Note: The cockpit cover is not designed to be used at highway
speeds. Do not tow your Regal boat with a cockpit cover installed
as personal injury and/or property damage could result. Purchase
a suitable travel cover designed for highway use before towing your
vessel. They can be ordered from your authorized Regal dealer.
Cockpit Cover
To Next Page
