44
Chapter 7
Aft Adjuster Strap
& Eyelet
Cockpit Cover
To install the cockpit cover follow these steps:
1. Locate the front of the cover and fasten it to the wind-
shield snaps.
2. As you snap the cover from bow to stern find the cock-
pit poles and install each one to the canvas cutouts desig-
nated for them. It is a good idea to mark them for future
use. Finish up fastening the snaps on the stern and exit
via the swim platform.
3. Do not use the cockpit cover as the only means of
supporting the vessel for winter storage outside. The cover
will not support heavy snow/ice loads. Use an approved
mooring cover with appropriate framework in colder en-
vironments or better yet store the vessel inside.
4
PREVENT POSSIBLE INJURY
AND/OR PROPERTY DAMAGE!
THE COCKPIT COVER IS DESIGNED
TO PROTECTTHE BOAT
FROM THE ELEMENTS.
DO NOT TRAVEL WITH THE COCKPIT
COVER INSTALLED
AS IS NOT DESIGNED FOR HIGHWAY USE!
!
!
EXHAUST FUMES FROM ENGINES
CONTAIN DEADLY CARBON MONOXIDE
(CO) GAS.BOATS WITH CANVAS
OR POOR VENTILATION
ARE MOST LIKELY TO COLLECT FUMES.
CO SICKNESS SYMPTOMS INCLUDE
HEADACHES, NAUSEA, & DIZZINESS.
DO NOT MISTAKE FOR SEA SICKNESS!
SEE CHAPTER ONE IN THIS MANUAL
FOR FURTHER INFORMATION.
IF EQUIPPED FASTEN
TIE
-
DOWNS
To Next Page
Loading...
