Doc ID: 191-7913A
NOTE: The Rekluse slave cylinder comes preassembled in
the kit. If the parts are separated, assemble them in the
following order: Rekluse slave cylinder, O-ring (the one
supplied or OE), then the supplied paper gasket. Not all
slave cylinders come with a gasket. If not supplied, use the
OE gasket.
NOTE: If you need to install the case sealing O-ring seal
(OE or Rekluse supplied), make sure it is seated against the
slave cylinder flange.
9. Torque the banjo bolt to OE specification.
To Next Page
Loading...
