11
2
Blood Glucose Tests
WARNING
• The meter should never be used
by more than one person. Do not
share the meter with anyone,
including family members, due to
the risk of infection from
bloodborne pathogens.
1,2
Do not
use on multiple patients!
• Blood glucose results can be
displayed in either mg/dL or
mmol/L. The back label of the
meter shows the unit of
measurement. This meter is set to
mg/dL. If the meter shows the
wrong unit, contact Customer
Service at 1-800-819-1097. The
correct unit of measurement in the
US is mg/dL. If you do not know
which unit of measurement is
correct for you, contact your
healthcare professional. Using the
wrong unit of measurement may
cause misinterpretation of your
actual blood glucose level and
may lead to improper therapy.
mg/dL is printed here
Using the ReliOn Platinum System
WARNING
To prevent inaccurate results:
• If you drop the meter or drop the meter
with a test strip inserted, the meter and/
or test strip could be damaged. Discard
the test strip and perform a control test
with control solution and a new, unused
test strip to ensure the meter and test
strips are both working properly. Then
repeat the blood glucose test with a new
test strip.
• DO NOT remove test strips from the test
strip container and put them into another
container, such as a plastic bag, pocket,
purse, wallet, etc. Storing test strips
outside of the test strip container can
damage the test strips and lead to
inaccurate results. It is important that
the test strips remain in their original
container until the time of use.
• DO NOT expose test strips to heat,
moisture, or humidity. Temperatures
outside the required range, as well as
moisture and humidity, can damage the
test strips and lead to inaccurate results.
• DO NOT bend, cut, or alter the test strips.
• DO NOT get dirt, food, or other material
on the test strip.
• When performing a blood glucose test,
remove your finger from the test strip
after the test strip is dosed and the
flashing hourglass symbol appears on
the meter. Failure to move your finger
away from the test strip during
measurement could give inaccurate
results.
83561_09410155001A EN ReliON.indd 1183561_09410155001A EN ReliON.indd 11 3/23/2022 11:23:56 AM3/23/2022 11:23:56 AM
To Next Page
Loading...
