Your Reloop IQ2 MIDI is more than just an analogue DJ mixer. With a professional, integrated 24
bit/96 kHz audio/MIDI interface it becomes a full-edged MIDI controller.
After the installation of the appropriate ASIO driver select the Reloop IQ2 MIDI as device in the
Preferences of Traktor under the item “Audio Setup”.
Two modes are intended for the IQ2 MIDI:
In the Traktor Preferences open the menu item “Output Routing” and set the outputs as
shown below:
Put the IQ2 MIDI‘s Channel Signal Input Selector -6- channel A to the USB1 position and channel B to the
USB2 position. This way the virtual Traktor channels will be routed to the mixer‘s hardware channels.
To Next Page
Loading...
Need help?
General
