If MIDI1 or MIDI2 respectively is activated the corresponding channel duct sends MIDI messages.
You can determine the MIDI channel that the IQ2 MIDI should use in order to send MIDI messages.
This is especially convenient if you would like to connect several IQ2 MIDI mixers or if other MIDI
controllers interfere with MIDI messages.
To do so proceed as follows:
- Hold the FX On button -19-
- Turn the X Parameter Encoder -25-
- The display will show “CH” (channel) and now you can adjust the channels from 1 to 16
To Next Page
Loading...
Need help?
General
