What to do if my REMEHA Quinta Ace 135 Boiler shows a Water Press Warning?
If your REMEHA Boiler displays a Water Press Warning, it indicates that the water pressure is too low. Check the water pressure.
What causes the WaterPressureOpen error on my REMEHA Quinta Ace 135 Boiler?
The 'WaterPressureOpen' error on your REMEHA Boiler means the hydraulic pressure sensor is open. To address this: * Check the wiring and connectors for bad connections. * Ensure the sensor is correctly fitted. * If the sensor is faulty, replace it.
Why does my REMEHA Quinta Ace 135 display Max Delta TH-TR error?
The Max Delta TH-TR error on your REMEHA Boiler indicates that the maximum difference between the heat exchanger and return temperature has been exceeded. This is often due to: * Insufficient or no flow: Check the circulation (direction, pump, valves). * Low water pressure: Check the water pressure. * A dirty heat exchanger: Check the cleanliness of the heat exchanger. * Air in the system: Check that the installation has been correctly vented to remove air. * Sensor error: Check that the sensors are operating correctly and that the sensor has been fitted properly.
What to do if REMEHA Boiler shows TFlow Open error?
If your REMEHA Boiler displays a 'TFlow Open' error, it means the flow temperature sensor is either removed. To fix this: * Check the wiring and connectors for bad connections. * If the sensor is faulty, replace the sensor.
Why is my REMEHA Quinta Ace 135 Boiler showing TFlow Closed error?
The TFlow Closed error on your REMEHA boiler means the flow temperature sensor is shorted. To resolve this: * Check the wiring and connectors for bad connections. * Ensure the sensor is correctly fitted. * If the sensor is faulty, replace the sensor.
What does Waiting For Configuration Number mean on my REMEHA Quinta Ace 135?
The 'Waiting For Configuration Number' error on your REMEHA Boiler indicates a configuration error or unknown configuration number. Reset CN1 and CN2 to resolve this.
What to do if my REMEHA Quinta Ace 135 has 5x Flame Loss Error?
If your REMEHA Boiler displays a 5x Flame Loss Error, it means flame loss has occurred 5 times. Here's what you should do: * Vent the gas supply to remove air. * Ensure the gas valve is fully opened. * Check the gas supply pressure. * Verify the operation and setting of the gas valve unit. * Confirm that the air supply inlet and flue gas outlet are not blocked. * Ensure there is no recirculation of flue gases.
What to do if my REMEHA Quinta Ace 135 Boiler displays warning A .00.00?
If your REMEHA Boiler displays warning A .00.00, the controls will continue to operate, but the cause of the warning must be investigated. Keep in mind that a warning can change into a blocking or lock-out.
What to do if my REMEHA Boiler displays error H .00.00?
If your REMEHA Boiler displays error code H .00.00, the controls will stop normal operation and will check with set intervals if the cause of the blocking still exists. Normal operation will resume when the cause of the blocking has been rectified. Note that a blocking can become a lock-out.
What to do if my REMEHA Quinta Ace 135 Boiler displays error E .00.00?
If your REMEHA Boiler displays error code E .00.00, the controls will stop normal operation. The cause of the lock-out must be rectified, and the controls must be reset manually.
To Next Page
General