What to do if my REMEHA Boiler displays error H .00.00?
If your REMEHA Boiler displays error code H .00.00, the controls will stop normal operation and will check with set intervals if the cause of the blocking still exists. Normal operation will resume when the cause of the blocking has been rectified. Note that a blocking can become a lock-out.
What to do if my REMEHA Quinta Ace 135 Boiler displays warning A .00.00?
If your REMEHA Boiler displays warning A .00.00, the controls will continue to operate, but the cause of the warning must be investigated. Keep in mind that a warning can change into a blocking or lock-out.
What to do if my REMEHA Quinta Ace 135 has 5x Flame Loss Error?
If your REMEHA Boiler displays a 5x Flame Loss Error, it means flame loss has occurred 5 times. Here's what you should do: * Vent the gas supply to remove air. * Ensure the gas valve is fully opened. * Check the gas supply pressure. * Verify the operation and setting of the gas valve unit. * Confirm that the air supply inlet and flue gas outlet are not blocked. * Ensure there is no recirculation of flue gases.
Why is my REMEHA Quinta Ace 135 showing a Max THeat Ex error?
The Max THeat Ex error on your REMEHA Boiler indicates that the maximum heat exchanger temperature has been exceeded. This can happen due to: * Insufficient or no flow - check the circulation (direction, pump, valves). * Low water pressure - check the water pressure. * Sensor issues - ensure the sensors are operating correctly and fitted properly. * A dirty heat exchanger - check the cleanliness of the heat exchanger. * Air in the system - ensure the central heating system has been correctly vented.
How to fix Max Tflow error on REMEHA Quinta Ace 135?
The Max Tflow error on your REMEHA Boiler means the flow temperature sensor is above the normal range. To resolve this: * Check the wiring and connectors for bad connections. * Ensure sufficient flow by checking the circulation (direction, pump, valves). * Verify the water pressure. * Inspect the heat exchanger for cleanliness.
What causes Max Delta TH-TF error in REMEHA Quinta Ace 135 Boiler and how to fix it?
The Max Delta TH-TF error in your REMEHA Boiler indicates that the maximum difference between the heat exchanger and flow temperature has been exceeded. This can be caused by: * No flow or insufficient flow: Check the circulation (direction, pump, valves). * Low water pressure: Check the water pressure. * A dirty heat exchanger: Check the cleanliness of the heat exchanger. * Air in the system: Check that the installation has been de-aired. * Poor water quality: Check water quality according to supplier's specifications. * Sensor error: Check that the sensors are operating correctly and that the sensor has been fitted properly.
What to do if my REMEHA Quinta Ace 135 Boiler shows Lock out Code E .00.00?
If your REMEHA Boiler displays a Lock out Code E .00.00, the controls will stop normal operation. You must identify and fix the cause of the lock-out, then manually reset the controls.
How do I fix a blocked flue gas pipe on my REMEHA Boiler?
If your REMEHA Boiler indicates a blocked flue gas pipe, check that the flue gas outlet is not blocked. After ensuring it's clear, restart the boiler.
What to do if my REMEHA Quinta Ace 135 Boiler shows a Water Press Warning?
If your REMEHA Boiler displays a Water Press Warning, it indicates that the water pressure is too low. Check the water pressure.
Why is my REMEHA Quinta Ace 135 Boiler overheating (Max Flow temp)?
If your REMEHA Boiler is showing a 'Max Flow temp' error, it means there is no flow or insufficient flow. You should: * Check the circulation (direction, pump, valves). * Check the water pressure. * Check the cleanliness of the heat exchanger.
To Next Page
General