automatic gearbox (use) ............................
(up to the end of the DU)
changing gear ............................................
(up to the end of the DU)
driving ........................................................
(up to the end of the DU)
automatic gearbox selector lever...............
(up to the end of the DU)
gear lever...................................................
(current page)
operation....................................................
(current page)
Shift Paddle ...............................................
(current page)
2.154
ENG_UD77256_3
Boîte de vitesses automatique Levier Electronique (HJB - Renault)
Driving in automatic mode
With the vehicle stationary and the
engine running, move the 1 selector
lever two notches backwards to engage
D position.
If one of the conditions is not applied,
D flashes for around 5 seconds and
the message “Push brake pedal” is dis-
played on the instrument panel for ap-
proximately 15 seconds.
In most road conditions you will en-
counter, you will not need to touch your
lever again: the gears will change au-
tomatically at the right time and at the
most suitable engine speed because
the automatic system takes into ac-
count the vehicle load and road contour
and adjusts itself to the particular driv-
ing style you have chosen.
Note: with the engine running and the
vehicle travelling at between 0 and
5 mph (0 and 8 km/h), in position N or
R, it is necessary to depress the brake
pedal to engage position D. This is
useful during parking manoeuvres re-
quiring a number of alternate forward
and reverse movements.
Economical driving
When driving, always leave the lever
in position D, keeping the accelerator
pedal lightly depressed to ensure auto-
matic gear changes at a lower engine
speed.
Accelerating and overtaking
Depress the accelerator pedal briskly
and fully (so that it goes beyond the
point of resistance).
It is also possible to shift down at any
time for overtaking purposes, by press-
ing the left-hand paddle.
To select reverse gear
With the vehicle stationary and the
engine running, move the 1 selector
lever two notches forwards to engage
position R.
If the brake pedal is not depressed, a
beep will sound, the display of position
R flashes for around 5 seconds in the
grid shown on the instrument panel,
and the message “Press Brake Pedal”
is displayed for approximately 15 sec-
onds.
Note: with the engine running and the
vehicle moving between 0 and 5 mph
(8 km/h), position N or D engaged, it
is not necessary to depress the brake
pedal to engage R. This is useful
during parking manoeuvres requiring
a number of alternate forward and re-
verse movements.
AUTOMATIC GEARBOX, ELECTRONIC LEVER (3/6)
To Next Page
Loading...
