2
5
1
NU760_1_G2-FRA.qxd 9/11/05 17:03 Page 2.29
CRUISE CONTROL/SPEED LIMITER: limiter function (continued)
2.29
Switching on
Press switch 1 on the ì side.
The indicator light in the instrument
panel lights up and, depending on
the vehicle, the trip computer or the
information display enters speed
limiter mode.
Limiting the speed
At a steady speed (above 18 mph
(30 km/h)) and in the correct gear
(for vehicles with manual gearboxes),
press switch 2: the speed is stored.
Varying the limit speed
The limit speed may be changed by
pressing repeatedly or holding
down:
- key 2 to increase the speed,
- key 5 to decrease the speed.
The system is designed in such a
way that it is possible to detect a
difference between the cruising
speed and the speed shown on
the instrument panel.
Driving
When a limited speed has been
stored, the vehicle works in a
similar way to vehicles without the
speed limiter function, as long as the
limited speed is not reached.
From this point, no effort on the
accelerator pedal will allow you to
exceed the programmed speed
except in an emergency (see
information on Exceeding the
limited speed).
NU760_1_G2-ENG.qxp 27-Dec-05 18:39 Page 2.29 (Black/Process Black plate)
To Next Page
Loading...
