Renault ESPASE 2005 - Clock and Exterior Temperature

2
1
NU760_1_G1-FRA.qxd 10/11/05 10:10 Page 1.66
1.66
CLOCK AND EXTERIOR TEMPERATURE
Exterior temperature
indicator
As ice formation is related
to exposure, local air
humidity and temperature, the
exterior temperature alone is not
sufficient to detect ice.
When the ignition is switched on,
the clock and (depending on the
vehicle) the exterior temperature are
displayed.
Setting the clock 1
Vehicle with button 2
- press and hold button 2 for
approximately three seconds;
- when the hour flashes, press
button 2 again to set it;
- wait approximately three seconds,
the minutes will flash, press
button 2 to set the minutes;
- wait approximately three seconds,
the minutes stop flashing, the
clock is set.
Vehicle without button 2 (vehicles
fitted with navigation assistance
system, radio etc.)
Refer to the equipment instructions
for the special features of these
vehicles.
Exterior temperature indicator
Special note:
When the exterior temperature is –
3°C to +3°C, the °C characters flash
(signalling a risk of ice on the road).
If there is a break in the electric
power supply (battery
disconnected, broken feed wire,
etc.), the clock will lose its time
setting.
The clock must be reset.
We recommend that you do not
adjust these settings while
driving.
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.66 (Black/Process Black plate)