1.113
ENG_UD60007_2
Eclairages et signalisations extérieures (X62 - Renault)
Automatic main beam
headlights (continued)
Activation/Deactivation
To activate automatic main beam
headlights:
– turn ring 3 until the AUTO symbol is
opposite mark 2;
– pull stalk 1 towards you.
Warning light
comes on the in-
strument panel.
To deactivate automatic main beam
headlights:
– pull stalk 1 towards you again;
– or turn ring 3 to a position other than
AUTO.
Warning light
goes out on the in-
strument panel.
EXTERIOR LIGHTING AND SIGNALS (4/5)
2
1
The “automatic main beam
headlights” system should
under no circumstances be
used to replace driver atten-
tion and responsibility with regard
to vehicle lighting and adapting to
light, visibility and traffic conditions.
Operating faults
When the message “WARNING: Check
Lighting” with warning light
©
is displayed and warning light
k
flashes on the instrument panel, this in-
dicates that there is a lighting fault.
Consult an approved dealer.
Each time you start the engine, pull
the stalk 1 towards you to reactivate
the system.
3
To Next Page
Loading...
