2.38
ENG_UD60008_2
Avertisseur d’angle mort (X62 - Renault)
BLIND SPOT WARNING (3/6)
4
B
C
D
If you overtake another vehicle, the in-
dicator 4 will only come on if that vehi-
cle remains for a long enough period in
your vehicle’s blind spot A .
The system’s detection range oper-
ates according to a standard lane
width. When driving in a narrow
lane, the function may warn you
when a vehicle is detected further
away than the nearest lane.
Conditions for non-function
– If the object is not moving;
– if traffic is heavy;
– the road is winding;
– if front and rear sensors both detect
an object at the same time (e.g.
when passing an articulated lorry).
– ...
If the vehicle is equipped with a towbar
recognised by the system, the mes-
sage “Trailer: blind spot warning OFF”
is displayed on the instrument panel in-
forming you that the function is not op-
erational. For information on the range
of equipment adapted to your vehicle,
we advise you to consult an approved
Dealer.
Display B
The function is activated and has not
detected any vehicles.
Display C
First warning: when the direction in-
dicator is not activated, the 4 warning
light signals that a vehicle is detected in
the blind spot.
Display D
When the direction indicator is acti-
vated, the 4 warning light flashes if a
vehicle is detected in the blind spot on
the side towards which you are about to
steer. If you cancel the direction indica-
tor, the function will return to the initial
warning (display C).
Due to the presence of sensors in
the bumper, it is advisable to en-
trust any operation on the bumper
(repair, replacement, paintwork,
etc.) to a qualified professional.
To Next Page
Loading...
