A
1
2
NU710_6_G1-FRA 4/03/05 9:32 Page 1.12
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T1-ENG.win 2/5/2005 9:37
-page18
1.12
REAR HEADREST
Positions for use
Press tab A of lock 1 and raise the
headrest to maximum height to use
it in the high position. Lower it until
it locks to use it in the low position.
To remove the headrest
Press tab A on locks 1 and 2 then
take out the headrest.
To refit the headrest
Insert the rods into the sleeves,
press the tabs on both rods and
lower the headrest.
Storage position
Press lock 2 and lower the headrest
completely.
The fully-lowered position of the
headrest is a storage position: it
should not be used when the seat is
occupied.
The headrest is important
for safety. Ensure that it is
fitted and in the correct
position.
To Next Page
Loading...
