1
3
2
4
NU710_6_G1-FRA 4/03/05 9:33 Page 1.35
J77 - NU710-5
C:\Documentum\Checkout\NU710_6_T1-ENG.win 2/5/2005 9:37
-page41
1.35
CHILD SAFETY (continued)
Installation
Rear-facing Isofix seat
When a rear-facing child seat is
fitted, the seatback should be close
to or touching:
- the dashboard (in the front seat),
- the front seatback (in the rear seat).
Forward-facing ISOFIX seat (rear
seats only)
When a front-facing child seat is
installed, the front seat must not be
moved back beyond the halfway
point on the seat runners and the
seatback must be in an upright
position.
Fitting the child seat seat base
- Before fitting and using the seat,
read the instructions provided
carefully;
- attach mounting guide 2 (supplied
with the child seat or as an
accessory), to rings 1 fitted to the
seat.
- Slide the seat catches 3 in the
guides 2 andpushtheseatfirmly
to lock it on the rings;
- Ensure that the seat is locked
correctly by moving it from left to
right and then forwards and
backwards;
- Push firmly on the base of the seat
to press the child seat cradle
against the vehicle seatback.
Fitting the child seat seatback
A rear-facing Isofix seat fitted to the
front passenger seat
The front passenger seat must be
adjusted so that the back of the child
seat is touching the dashboard.
Use belt 4 supplied with the seat:
- attach the belt hook to the ring
located underneath the seat on the
side nearest the door, marked by a
labelnexttothering,
- tighten the belt.
To Next Page
Loading...
