Renesas RA Microcontrollers EK-RA6M2 v1 – User's Manual
R20UT4578EU0102 Rev.1.02 Page 29 of 32
Jul.29.20
5.6.5.4 VCC_USB
By default, the Main MCU pin VCC_USB is connected to the +3V3 MCU supply voltage.
Alternatively, this pin may be connected to the MCU pin header J1. To do this, copper jumper
E8 must be open and copper jumper E14 must be closed.
Figure 34. VCC_USB Circuit
5.6.5.5 Signal P205
By default, the Main MCU pin P205 is connected to a TSCAP-A capacitor. This pin may be
connected to the MCU pin header J2. To do this, copper jumper E12 must be closed. The
TSCAP-A capacitor may be disconnected by making copper jumper E15 open.
Figure 35. P205 Circuit
To Next Page
Loading...
