RH850/F1x StarterKit V3 User Manual
R01UH0724ED0120 Page 19
January 2018
4.2.2 Microcontroller Area and Port Pin Interfaces
On the different versions of the RH850/F1x StarterKit the following device are assembled:
Y-ASK-RH850F1L-V3: R7F701057
Y-ASK-RH850F1K-V3: R7F701587
Y-ASK-RH850F1H-V3: R7F701527
Y-ASK-RH850F1KM-S4-V3: R7F701649
Y-ASK-RH850F1KH-D8-V3: R7F701709
As external clock supply of the microcontroller, a 16MHz crystal oscillator and a 32.768kHz sub-
oscillator is mounted.
Each microcontroller I/O pin is connected to a pin header interface. The pin header interfaces
allow easy probing of I/O pins and provide the ability to selectively connect the I/O pins to power,
ground or other signals. Table 1 and Table 2 are showing the assignment of the pin header
interface.
Certain GPIO pins of the device might not be available on all StarterKit versions. An overview of
these pins can be found in Table 10.
Table 10. GPIO pins available on different board version (•: available, -: not available)
To Next Page
Loading...