Renfert SILENT compact - Cleaning and Maintenance; Cleaning Procedures; Additional Information

EN
Cleaning / Maintenance
Opening the device, other than for the processes described below, is not permissible!
Cleaning
Use a damp cloth to clean the outside of the unit.
Do not use abrasive or solvent-based cleaning agents.
Empty Dust Drawer
After the set time period has expired a signal to empty the dust drawer will occur (factory settings 50 h).
Before the dust drawer is emptied, a lter cleaning function is carried out so that loose dust particles fall
into the dust drawer.
The time period has expired:
♦ An acoustic signal will occur 3 times.
♦ The display dust drawer (24) lights up.
When the suction has stopped, an acoustic signal occurs 3 times and a lter cleaning function is carried
out.
When the lter cleaning function has nished:
⇒ Pull the dust drawer (3) out to the front and empty.
⇒ Replace the dust drawer until it clicks into place.
⇒ Press the enter key (25) (the counter which determines the time period is re-set).
♦ An acoustic signal conrms the input.
♦ The display dust drawer (24) light disappears.
If the dust drawer is not emptied, the display for the dust drawer will remain alight (24). When the
unit is switched off / on an acoustic signal will occur to remind that the dust drawer needs
emptying.
For information on setting the required time period see the quick reference card which is supplied or go to
the instructions for use in the Internet.
Change Fine Filter
► If the suction power is no longer sufcient in spite of a lter cleaning, the ne lter must be
changed.
► In general, the ne lter should be changed every 2 years.
Do not clean the ne lter manually (e.g. with compressed air, brush, water, etc.), as this leads to
damage of the lter material!
When installing the ne lter please ensure that it is positioned correctly, otherwise leakages may result.
See the assembly instruction at the end of the instruction manual, which is also attached to the new ne
lter.
Spare Parts
You can nd components subject to wear and the spare parts on the spare part
list in the internet at www.renfert.com/p918.
Enter the following item number: 29340000
The components excluded from the warranty (such as consumables or parts
subject to wear and tear) are marked on the spare part list.
Disposal Information
Within the European Union, units with this symbol should not therefore be disposed of in unsort-
ed domestic waste.
Please contact your local authorities for more information on proper disposal.
Subject to change
- 4 -