EN
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing. Devices with damaged
connection cables, tubes or housing parts or other defects must not be operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure the
device is not used. Send the device for repair!
► Only operate the device under supervision.
► Observe the accident prevention regulations by the trade association!
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702 (As-
sociation for Electrical, Electronic and Information Technologies).
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support area.
Specic Information
► The power socket on the device may only be used for the purpose specied in the instructions for
use. The connection of other electronic devices could lead to material damage.
► Before connecting an electronic device to the power socket, ensure that the electronic device is
rst switched off.
► Read the operating instructions of the other appliance and comply with the safety instructions
contained in the document.
► Please observe the national regulations and permitted exposure to dust in a working environment.
Please ask the “National Institute for Occupational Safety and Health” or other responsible au-
thority.
► Always refer to the relevant safety data sheets, when extracting hazardous materials.
► Always wear protective gear, when extracting hazardous materials.
► It is necessary to wear suitable personal protective equipment when emptying the dust drawer or
cleaning, depending on the type of extracted material.
► When disposing of the extracted material or used lter, please observe the local specications
and accident prevention regulations!
► Make sure the dust drawer is fully closed during operation.
► Do not operate without a suction hose.
► Do not extract ammable or explosive gasses, fumes or dust.
► Do not extract hot materials.
► Do not extract liquids.
► If the dust extractor is employed to extract hazardous materials, appropriate personal protective
gear must be worn and steps must be taken to ensure that the exhaust air is properly ventilated.
Please refer to the associated safety data sheets for specic requirements.
► Dispose of extracted material according to local statutory regulations.
Authorized Persons
Operation and maintenance of the device may only be performed by qualied personnel.
Product Description
Components and Functional Elements
See Fig. 1 (on inside cover)
1 SILENT compact
2 Key-pad
3 Dust drawer
4 Fine lter
5 Mains cable
6 Suction hose
7 Exhaust air lter / exhaust air outlet
See Fig. 2 (on inside cover)
20 Display automatic operation
21 Operating mode key, automatic,
continuous operation
22 Display continuous operation
23 Suction level key
24 Display empty suction drawer
25 Enter key, save input
26 Display error message
8 Suction port
9 On / Off switch
10 Power supply
11 Device protection switch
12 Unit power socket
13 Service ap
- 2 -
To Next Page
Loading...
