Renishaw NC4+ Blue - Page 4

NC4+ Blue non-contact tool setting system installation guide
ii
Contents
Software routines ........................................................3.10
Aligning an NC4+ Blue system
..............................................3.11
Alignment tolerances
.....................................................3.12
Maintenance
.................................................................... 4.1
Introduction
................................................................4.1
Removing and refitting the filter elements
.........................................4.2
Removal and replacement of membrane dryer module
..............................4.2
Dew point indications
......................................................4.2
Cleaning the optics
..........................................................4.4
Cleaning the NC4+ Blue
....................................................4.4
To clean the optics
........................................................4.5
Replacing the air blast nozzle
...............................................4.7
Set up and re-alignment of an NC4+ Blue unit
...................................4.8
Using a voltmeter
.........................................................4.9
Using the set-up tool
.....................................................4.10
Replacing the set-up tool battery
............................................4.10
Fault-finding
....................................................................5.1
Parts list
.......................................................................6.1
Software and user information
.................................................6.7
Machine tool apps
...........................................................6.7
General information
.............................................................7.1
Disclaimer
.................................................................7.1
Trade marks
................................................................7.1
Warranty
..................................................................7.1
China RoHS
...............................................................7.1
Changes to equipment
.......................................................7.1
Microchip software licensing agreement
..........................................7.2
CNC machines
.............................................................7.2
Care of system components
...................................................7.2
Patents
...................................................................7.2
EU declaration of conformity
...................................................7.3
WEEE directive
.............................................................7.3
REACH regulation
...........................................................7.3
FCC information to user (USA only)
.............................................7.4