Renishaw NC4+ Blue - Default Chapter; Table of Contents

i
Contents
Safety ........................................................................1.1
Safety
....................................................................1.1
Warnings
..................................................................1.2
Laser safety and warning labels
................................................1.3
Location of the laser aperture
..................................................1.3
NC4+ Blue basics ............................................................2.1
Guidelines for best practice
....................................................2.1
Access panel identification markings
............................................2.2
Probe status LED function
.....................................................2.2
Transmitter (Tx) and receiver (Rx) dimensions
.....................................2.4
Mounting adjuster plate dimensions
.............................................2.5
Cable with connector dimensions
...............................................2.5
NC4 set-up tool dimensions
...................................................2.6
Introduction
.............................................................2.6
Dimensions
.............................................................2.6
Battery specification
.......................................................2.7
NC4+ Blue specification
......................................................2.8
NC4+ Blue system vs. minimum tool diameter
.....................................2.8
System installation ...........................................................3.1
Installing the NC4+ Blue system
................................................3.1
Introduction
.............................................................3.1
Best practices
............................................................ 3.2
How to install and configure the NC4+ Blue system
..............................3.2
Installing the air assembly kit
................................................3.3
Installing an NC4+ Blue system
..............................................3.4
Installing the interface
.....................................................3.7
NC4+ Blue system wiring details
.............................................3.8
Supplying electrical power to the NCi-6 interface unit
.............................3.8
Power loss and restoration
..................................................3.8
Setting the NC4+ Blue system air pressure
.....................................3.9
Setting the air blast pressure
...............................................3.10