28
Glue connection of the heating plate.
1x ceramics plate
1x heating
4x spacer bolts
Plug the spacer bolts with the thread bores to the bottom of
the ceramics plate (side with tissue structure) and provision
-
ally fasten with 4 screws.
Caution: Only tighten the screws slightly since there is the
danger that the ceramics plate will break otherwise.
Check the alignment of the heating by pushing the heating
across the spacer bolts. The heating must then be supported
fold-free with the side with the protection foil against the bot-
tom of the ceramics plate and must not protrude at the edges.
Clear the bottom of the ceramics plate of dust and grease with
a rag and solvent.
Then remove the protective foil from the heating and finally
glue the heating to the bottom of the ceramics plate without
blisters.
To Next Page
Loading...
