33
Assembly of the pinions at the thread circulation spindles
2x sprocket 28Z (large pinion, outer dia. 32 mm)
1x basic frame
4x threaded pins M3x5
Push sprockets onto the ends of the thread circulation spin
-
dles and attach with the threaded pins.
Then align the position of the pinions so that the toothed areas
are at a level with the toothed area of the motor pinion.
Aligning the thread circulation spindles
Measure the distance between the bottom plate and the Y-
plate with a calliper.
The distance must be precisely the same on both sides.
If required, the distance can also be adjusted by turning the
spindles.
To Next Page
Loading...
