EasyManua.ls Logo

Renkforce WH2315 - Page 72

Renkforce WH2315
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72
Setting function "TIME SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Use the " " (4) button to select the desired subfunction:
Subfunction "TIME FORMAT": Select the display format for the time
Use the "
" (1) or " " (2) buttons to choose between "12H" (12 h display formal) or "24H" (24 h display formal).
In12hdisplayformat,"am"willbedisplayedtotheleftofthetimeinthersthalfoftheday,and"pm"inthesecond.
Subfunction "DATE FORMAT": Select the display format for the date.
Use the "
" (1) or " " (2) buttons to select the display sequence for the date ("DD"), month ("MM") and year
("YYYY").
Subfunction "ENTER TIME": Manual setting of time and date
In case of receiver problems for the DCF signal, the time and date can be set manually.
Changetherespectiveashingvaluewiththe"
" (1) or " " (2) buttons (for quick adjustment, keep the respec-
tive button pushed).
Brieypushthe"
" (4) button to switch between the settings for hours, minutes, day, month and year.
Subfunction "TIME ZONE": Setting the time zone
Use the "
" (1) or " " (2) buttons to select the time zone in the range of +12...-12 hours.
Subfunction "RCC RECEIVE": Switching DCF reception on/off
Use the " " (1) or " " (2) buttons to switch DCF reception on ("ON") or off ("OFF").
Subfunction "DAYLIGHT SAVING TIME": Automatic daylight saving time adjustment
This setting function appears only if DCF reception has been switched off in the previous setting function ("OFF").
In this case, the "
" (1) or " " (2) buttons can be used to switch automatic daylight savings time adjustment on
("ON") or off ("OFF").
Subfunction "NORTH/SOUTH": Setting for northern/southern hemisphere for moon phase display
Here, you can set if the basis station is located in the northern or the southern hemisphere of the earth to display
the moon phase correctly.
Use the "
" (1) or " " (2) buttons to choose between "NORTH" (northern hemisphere of the earth) and "SOUTH"
(southern hemisphere).

Table of Contents

Related product manuals