Renkforce WH2315 - Page 73

73
Setting function "UNIT SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the " "(3)brieyrepeatedlyuntilthesettingfunction"UNITSETTING"isdisplayed.
Use the "
" (4) button to select the desired subfunction:
• Subfunction "LIGHT UNIT": Unit of lighting strength
Use the " " (1) or " " (2) buttons to select the desired unit for the lighting strength (you can set W/m², lux, fc).
• Subfunction "TEMPERATURE UNIT": Unit of the temperature
Use the "
" (1) or " " (2) buttons to select the desired unit for the temperature (you can set °C, °F).
• Subfunction "BAROMETRIC UNIT": Unit of the barometric pressure
Use the "
" (1) or " " (2) buttons to select the desired unit for the barometric pressure (you can set hPa, mmHg,
inHg).
• Subfunction "WIND SPEED UNIT": Unit of the wind speed
Use the " " (1) or " " (2) button to select the desired unit for the wind speed (you can set km/h, bft, m/s, knots,
mph)
• Subfunction "RAINFALL UNIT": Unit of the rain volume
Use the "
" (1) or " " (2) buttons to select the desired unit for the rain volume (you can set mm, inch).
Setting function "RECORD SAVE INTERVAL"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the "
"(3)buttonbrieyrepeatedlyuntilthesettingfunction"RECORDSAVEINTERVAL"isdisplayed.
Thenbrieypushthebutton"
" (4).
Use the "
" (1) or " " (2) buttons to select the desired recording interval for the measured values.
 Theshortertherecordingdurationisset,thefasterwilltheinternalmemoryllandthemoreoftenwillyou
have to read the values on the computer.
Setting function "RAIN SEASON SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the "
"(3)buttonbrieyrepeatedlyuntilthesettingfunction"RAINSEASONSETTING"isdisplayed.
Thenbrieypushthebutton"
" (4).
Use the "
" (1) or " " (2) button to choose the start of the month as of which the total rain volume will be deleted.