74
Setting function "BAROMETRIC SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the " "(3)brieyrepeatedlyuntilthesettingfunction"BAROMETRICSETTING"isdisplayed.
Use the "
" (4) button to select the desired subfunction:
• "CURRENT WEATHER": Current weather
Use the " " (1) or " " (2) buttons to set the current weather. This increases accuracy of the weather forecast
symbols in the display of the basis station.
• "BAROMETRIC PRE-SET": Step width for bar chart display
Use the "
" (1) or " " (2) buttons to set the step width for the bar chart display. For example, if you set "2", each
bar of the bar chart display will correspond to the barometric pressure change of 2 hPa.
• "BAROMETRIC PRE-STORM": Barometric pressure change for storm recognition
Use the "
" (1) or " " (2) buttons to set a value as of which barometric pressure change the basis station will
recognise a storm. If, for example, "7" is set, an air pressure change of 7 hPa within one hour will lead to storm
recognition.
• "BAROMETRIC COORDINATES": Time selection for bar chart display
Use the " " (1) or " " (2) buttons to set the duration for the bar chart display (the last 12 or 24 hours).
Setting function "CONTRAST SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the "
"(3)brieyrepeatedlyuntilthesettingfunction"CONTRASTSETTING"isdisplayed.
Thenbrieypushthebutton"
" (4).
Use the "
" (1) or " " (2) buttons to set the contrast for the LC display.
Setting function "KEY BEEP SETTING"
After starting setting mode (keep the "SET" (5) button pushed for 2 seconds), the setting function "TIME SETTING"
will appear.
Then push the "
"(3)brieyrepeatedlyuntilthesettingfunction"KEYBEEPSETTING"isdisplayed.
Thenbrieypushthebutton"
" (4).
Use the "
" (1) or " "(2)buttonstoselectwhetherabriefconrmationsoundistobeoutputateverypushofa
button or not.
To Next Page
Loading...