EasyManuals Logo

ResMed AIRCurve 10 S User Manual

ResMed AIRCurve 10 S
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
English 9
2. Check the air tubing and replace it if there are any holes, tears or cracks.
3. Check the air filter and replace it at least every six months. Replace it more often if there are any
holes or blockages by dirt or dust.
To replace the air filter:
1. Open the air filter cover and remove the old air filter.
The air filter is not washable or reusable.
2. Place a new air filter onto the air filter cover and then close it.
Make sure the air filter is fitted at all times to prevent water and dust from entering the device.
Reassembling
When the water tub and air tubing are dry, you can reassemble the parts.
1. Connect the air tubing firmly to the air outlet located on the rear of the device.
2. Open the water tub and fill it with distilled room temperature water up to the maximum water
level mark.
3. Close the water tub and insert it into the side of the device.
4. Connect the free end of the air tubing firmly onto the assembled mask.
Therapy data
Your AirCurve 10 device records your therapy data for you and your care provider so they can view
and make changes to your therapy if required. The data is recorded and then transferred to your care
provider wirelessly or via an SD card.
Wireless
Your AirCurve 10 device is equipped with cellular communication. This allows your therapy data to
be wirelessly transmitted to your care provider to enhance the quality of your treatment. It also
allows therapy settings to be updated in a more timely manner or your device software to be
upgraded. The Wireless signal strength icon
displayed at the top right of your screen indicates
the signal strength.
The data is usually transmitted after therapy has stopped. In order to make sure that your data is
transferred, leave your device connected to the power outlet at all times and make sure that it is not
in Airplane Mode.
Notes:
x Therapy data might not be transmitted if you use it outside of the country or region of purchase.
x Devices with cellular communication might not be available in all regions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ResMed AIRCurve 10 S and is the answer not in the manual?

ResMed AIRCurve 10 S Specifications

General IconGeneral
Operating ModeS (Spontaneous)
Ramp Time0 to 45 min (5-min increments)
Device TypeBilevel Positive Airway Pressure (BiPAP) Device
Pressure Range4-25 cm H2O
HumidificationIntegrated HumidAir Humidifier
Sound Level26 dBA
Power Supply100-240V AC, 50/60Hz, 1.5A
Data StorageSD card
ConnectivityWireless
CompatibilityCompatible with ResMed mask systems

Related product manuals