EasyManuals Logo

ResMed AIRCurve 10 S User Manual

ResMed AIRCurve 10 S
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
8
Caring for your device
It is important that you regularly clean your AirCurve 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
Disassembling
1. Hold the water tub at the top and bottom, press it gently and pull it away from the device.
2. Open the water tub and discard any remaining water.
3. Hold the cuff of the air tubing and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
Cleaning
You should clean the device weekly as described. Refer to the mask user guide for detailed
instructions on cleaning your mask.
1. Wash the water tub and air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.
Checking
You should regularly check the water tub, air tubing and the air filter for any damage.
1. Check the water tub:
x Replace it if it is leaking or has become cracked, cloudy or pitted.
x Replace it if the seal is cracked or torn.
x Remove any white powder deposits using a solution of one part household vinegar to
10 parts water.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ResMed AIRCurve 10 S and is the answer not in the manual?

ResMed AIRCurve 10 S Specifications

General IconGeneral
Operating ModeS (Spontaneous)
Ramp Time0 to 45 min (5-min increments)
Device TypeBilevel Positive Airway Pressure (BiPAP) Device
Pressure Range4-25 cm H2O
HumidificationIntegrated HumidAir Humidifier
Sound Level26 dBA
Power Supply100-240V AC, 50/60Hz, 1.5A
Data StorageSD card
ConnectivityWireless
CompatibilityCompatible with ResMed mask systems

Related product manuals