EasyManuals Logo

ResMed AIRCurve 10 S User Manual

ResMed AIRCurve 10 S
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
English 7
To adjust the Humidity Level:
1. In My Options, turn the dial to highlight Humidity
Level and then press the dial.
2. Turn the dial to adjust the humidity level and press
the dial to save the change.
If you continue to get a dry nose or mouth, or moisture in your mask, consider using ClimateLineAir
heated air tubing. ClimateLineAir together with Climate Control delivers more comfortable therapy.
Mask Fit
Mask Fit is designed to help you assess and identify possible air leaks around your mask.
To check Mask Fit:
1. Fit the mask as described in the mask user guide.
2. In My Options, turn the dial to highlight Run Mask Fit and then press the
dial.
The device starts blowing air.
3. Adjust the mask, mask cushion and headgear until you get a Good result.
To stop Mask Fit, press the dial or Start/Stop. If you are unable to get a good mask seal, talk to your
care provider.
More options
Your care provider may have given you access to personalize a few more options.
Leak Alert
When Leak Alert is enabled, the device beeps if the mask leaks too much air
or if you remove the mask during therapy.
SmartStart
When SmartStart is enabled, therapy starts automatically when you breathe
into your mask. When you remove your mask, it stops automatically after few
seconds.
Mask
This option shows your mask type setting. If you use more than one type of
mask, adjust this setting when switching between masks.
Run Warmup
This option allows you to pre-heat the water before starting therapy, so that
the air is not cold or dry at the beginning of therapy.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ResMed AIRCurve 10 S and is the answer not in the manual?

ResMed AIRCurve 10 S Specifications

General IconGeneral
Operating ModeS (Spontaneous)
Ramp Time0 to 45 min (5-min increments)
Device TypeBilevel Positive Airway Pressure (BiPAP) Device
Pressure Range4-25 cm H2O
HumidificationIntegrated HumidAir Humidifier
Sound Level26 dBA
Power Supply100-240V AC, 50/60Hz, 1.5A
Data StorageSD card
ConnectivityWireless
CompatibilityCompatible with ResMed mask systems

Related product manuals