Doc 0452940 rev. A
Page 10 of 14
Not subject to issue control when printed
Q-flex tubing
p/n 10049101
Silicone tubing
p/n 10929-000
Solder the wires - Paste Rec Insulation Tape
NOTE: Peters coat must be added after soldering
For LP
For - MP-HP
Receiver Assembly C6 CIC
Paste Rec Insulation Tape in the solder joint of REC
Wrap Rec with Tubing,silicone p/n 10929-000.
Place Tubing,silicone uncut 1.3mm around Rec&Wrap
HP MP LP
Place the Q-flex tubing as shown. Bend the wires.
Cut the silicone tubing to 1.3 mm and place it over the wires
To Next Page
Loading...
