Doc 0452940 rev. A
Page 6 of 14
Not subject to issue control when printed
Raw blank faceplate w/o module Using a tweezer, Pick up module
by contact to avoid damaging the
plastic
Insert module into slot in face-
plate. Contacts point toward
hinge pin
Ensure that the I-Block prog
module is placed evenly (both
ends) on faceplate. Module is not
snapped in all the way
Use a tweezer and press down until it clicks into place. Module is
snapped in and flush to surface of faceplate
“CLICK”
Note: No adhesive necessary to place I-Block module
on faceplate
Installing Programming Module on faceplate
To Next Page
Loading...
