Doc 0452940 rev. A
Page 13 of 14
Not subject to issue control when printed
NOTE: Test parts to be used for testing on DSA6000
When testing/programming
a batt pill must be used:
p/n 17449200, size 10A
Programming cable sets mentioned can be used
2cc coupler
p/n 30-4838800
to be ordered with GTO
Dept/HQ Ballerup DK
Either of the shown 2cc coupler
inserts can be used. Both inserts can
be ordered with GTO in HQ. More
info to be found on GTO website
under “DSA6000 Documentation”
Connect the flex to the prog cable
by using the flex end marked with
an arrow
• Prog cable CS63
op/n 15206700 (right)
p/n 15206701 (left)
Strip, Flex, CS63 PRG
p/n 19181700
Hi-Pro Programming cable CS44:
p/n 9022 907 69029, Left (Blue)
p/n 9022 907 69019, Right (Red)
Flex Connector Clip CS63
p/n 3122 150 73781
Strip, Flex, CS63 PRG
p/n 19181700
CS44 cable
Hi-Pro Programming cable CS44:
p/n 9022 907 69029, Left (Blue)
p/n 9022 907 69019, Right (Red)
Adapter, Flex, 3 PIN, CS53
P/N 19533900
Adapt Flex,
3 PIN CS53
OR OR
Test Equipment C6 CIC
To Next Page
Loading...
