26 27
CALIBRATE TONNEAU COVER
• Cover module needs calibration after:
• Cabin module went in and out of Pairing mode
• After a power cycle on the cover module
• Calibration must reach the fully open extremity and fully close extremity of the tonneau cover.
• Once the calibration is complete, the cover module will move at the normal speed.
3x OEM Lock – Cover close command
3x OEM Unlock – Cover open command
Button 9/0 – Cover close command
Button 1/2 – Cover open command
SYSTEM INSTALLATION COMPLETE
• Once the tonneau cover is assembled, the cables
that drive to move the cover are not aligned properly.
•
• After a power cycle was performed to the Cover
module, the rst uninterrupted cover operation
will perform a calibration.
• If the Cabin module went in and out of pairing mode,
the rst uninterrupted cover operation will also be
running at a safe speed to perform a calibration.
•
• Once calibration is complete, the cover will run at
the normal operating speed.
To Next Page
Loading...
