Step 4. Mounting the Rear Camera and Wiring the Cables
4.1 Choose the Installation Location:
Near the License Plate: Mounting the camera near the license plate
offers a clear rear view and ensures coverage of the back area.
4.2 Connect the Extension Cable:
Connect one end of the extension cable to the power input and video
output ports on the rear dash cam.
4.3 Route the Extension Cable:
Securely route the extension cable along the interior of the vehicle,
making sure to avoid any moving parts or obstructing airbags. Use cable
clips or ties to secure the cable in place.
8
Step 3. Power on the Camera and Format the Memory Card
Power the camera by connecting the charger to the car cigarette lighter
and camera. Before you start using a new memory card, you MUST
format the card within the camera using the format function. Always
backup important data stored on the memory card before formatting.
To format the memory card, make sure you have inserted your memory
card, then turn on the device by connecting to a power source. Press OK
to stop recording. Then toggle to the format settings and confirm the
selection. You may now disconnect from power. The camera will shut
down after 3 seconds. The camera should begin recording automatically
the next time it is powered on.
To Next Page
Loading...
