© 1998-2006 RF IDeas, Inc.
Device Found
This indicates the type of pcProx or AIR ID Enroll reader
found (RS-232 or USB). The configuration program
automatically checks for a USB reader first, and if it does
not find one, it scans COM ports 1 through 8 for a serial
port model.
Reset to defaults
This button is used to put the device back into a know
state. All configuration settings are set back to their
factory defaults.
Con fig changed
This checkbox is selected by the program to indicate to
the user any modifications made to the configuration
which have not been written to the device.
Test RS--232
Check this box to view ASCII card data in the field
below. Note selecting this checkbox disables the
configuration from working with the devices flash
memory. De-select this checkbox in order to continue
configuring the reader.
Read pcProx
Use this button to read the device’s current
configuration.
Write to pcProx
This button is used to write the configuration settings
displayed to the device.
WARNING: Do not write the configuration while a card is
being read on the reader. This may cause a connect error.
If you receive this error, you may need to detach the
reader and plug it back in to cure the error.
To Next Page
Loading...
