9. Attach the LNB Arm (choose your direction on Page 13 based on your provider) loosely to the
Reflector using 4 of the ¼”- 20 x 3/4” screws provided. The LNB Arm should be able to be pivoted
upwards into the Reflector after it is attached. Tighten all 6 screws using a #3 Philips screwdriver.
10. To install the LED Lights onto the reflector, Splice the Black and Red wires using the Scotch-Lok
connectors (red button). It is not necessary to strip the wires. Place the ends of the wires (red to red,
black to black) deeply into the connector and pinch with pliers. This will connect the LED’s that will
reflect onto the dish at night. (If you choose not to connect the LED lights, remove, or securely isolate
as they have constant 12VDC.) Tuck the Scotch-Lok connectors through the hole in the dish.
To Next Page
Loading...
