The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
RefGuide_U-routerNGW_v1.01.docx Page: 18(57)
9.3 User shells
Users can have different shells on the U-router NGW system. For example, some users are not
allowed to use SSH and then perform CLI commands. Other users are meant to have direct access
to the Console port of the connected Enterprise Router. User can have 4 different shell types,
dependent on their role.
The four different shell types available:
User has Web GUI and SSH access. When the user logs
in using SSH he/she will get a CLI prompt. Similar
to: rfi@rfi-000102:~$
User has Web GUI and limited SSH access. When the
user logs in using SSH he/she will get a minicom
terminal. No shell commands can be given.
User has Web GUI access. When logged in over SSH
the user is connected straight to the Console port
of the attached Enterprise Router.
User has Web GUI access only. No SSH login is
allowed
The shell type for each user can be set on the Users tab.
Figure 13: Different types of login shells available for users
To Next Page
Loading...
Need help?
General