EasyManuals Logo
Home>RFI>Network Router>U-router NGW

RFI U-router NGW User Manual

RFI U-router NGW
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
RefGuide_U-routerNGW_v1.01.docx Page: 46(57)
14.8 Interface
The ‘interface’ endpoints provide information about all IP interfaces on the U-router NGW. You
can retrieve or set the interface IP configuration for the Ethernet, mobile and virtual interfaces on
the unit.
ENDPOINTS
GET /api/interface
POST /api/interface
You can use the GET /api/interface endpoint to retrieve the status of the interfaces.
For example:
curl https://192.168.168.1/api/interface -u rfi:rfi123
Returns:
{
"interfaces": [{
"id": "eth0",
"mac": "40:28:14:fe:dd:b7",
"state": "up",
"method": "static",
"ip": "192.168.168.1",
"mask": "255.255.255.0",
"metric": "125",
"defaultGateway": "192.168.168.253",
"nameServer1": "192.168.168.42",
"nameServer2": "62.140.138.233"
}, {
"id": "wwan0",
"mac": "",
"state": "up",
"ip": "109.33.58.206",
"mask": "255.255.255.252",
"gateway": "109.33.58.205",
"metric": "25"
}, {
"id": "tun0",
"state": "down",
"ip": "0.0.0.0"
}, {
"id": "ppp0",
"state": "down",
"ip": "0.0.0.0"
}],
"status": "OK"
}
You can use the POST /api/interface endpoint to set the parameters of interface identified by the
‘id’.
The possible POST parameters are:
method
Sets the interface either to staticor dhcp. When set
to static you must also specify the iptogether with
mask
ip
The IP address of the interface, when method is set to
static’.
mask
The netmask of the interface when method is set to static
metric
Metric is the value that is assigned to an IP route for a
particular network interface that identifies the cost that
is associated with using that route. The lower the value,
the higher the preference for this interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RFI U-router NGW and is the answer not in the manual?

RFI U-router NGW Specifications

General IconGeneral
BrandRFI
ModelU-router NGW
CategoryNetwork Router
LanguageEnglish