Explanation: No hot water is delivered when water is
flowing through unit and remote control displays the
hot water temperature setting. [For ‘NO POWER’
complaint (remote control will not turn on) – check
wall outlet for 120 volts. If voltage is present, check
the two 3-amp fuses at the control board]
Water Flow:
1. Use cold water shutoff valve to turn OFF
water supply to unit. Turn remote control
OFF; unplug power cord at wall outlet. Wait
10 seconds; plug power cord back into outlet;
wait 20 seconds; turn the remote control ON.
Turn water supply ON; check the nearest hot
water fixture for hot water.
2. Open multiple hot water fixtures. If unit fires
then there is not enough water flow to
engage the unit at a particular fixture. Check
your fixture aerator screen(s) for debris.
Clean if necessary.
3. Your water flow may be restricted by debris in
water filter. Remove the water filter and
inspect. Clean if necessary.
4. Your water lines might be crossed. Make
sure your hot and cold water supply lines are
connected to the appropriate hot and cold
water assembly connections on the unit.
To Next Page
Loading...
