DETAILED DEVICE DESCRIPTION
1. Power Entry Module
2. Mains Fuses 12 Amp
@ 250 VAC 5mm x20mm
3. Power Switch
4. Power Indicator Lamp
5. Heat/Drain Select Switch
(Deluxe Model Only)
6. Low Voltage Control Fuse
(500mA @ 205V)
7. Voltage Requirement
(120 VAC)
8. Drain Hose with Shut-O
Valve (Standard Model)
9. Drain Valve and Removable
Filter (Deluxe Model)
8
7
Enclosure Panel (115/120VAC Deluxe shown) Rear Cavity - Standard Model Rear Cavity - Deluxe Model
HydraTherm Heating Units come standard
with the Divider System as shown below in
Figure 1. The Divider System functions as a
vertical drawer by raising the heat packs for
easy removal.
The Divider System can be substituted for
the Traditional Rack System shown in Figure
2. Made from the same composite material,
the Rack System sits lower inside the tank
and functions like traditional stainless steel
racks.
Shelf clips are included with both systems,
and can be connected to any of the four (4)
positions on each Divider or Rack. See page
6 for recommended shelf clip positions.
NOTE: The front rail of the first divider is thin
compared to the other dividers and should
be positioned as such in the tank, as seen in
Figure 3.
Figure 1. Divider System Figure 3. Divider Rail Comparison
Figure 2. Traditional Rack System
5
9
To Next Page
Loading...
