Richmar HydraTherm - Recommended Pack Setup

RECOMMENDED PACK SETUP
When purchasing HydraTherm Heating
Units, customers have the option of
including 12 HydraHeat Packs with their
purchase. This includes three of each size:
universal, cervical, standard and oversize.
Recommended setup uses 2 of the 3
included clip-on shelves, one at the
bottom position on the back of the rear-
most divider. The second is placed at the
top position of the front divider (Fig. 1).
The third can be stored for later use, or
used if a dierent configuration is desired.
The recommendation for setup of clip-on
shelves and pack placement is illustrated
below (Fig. 2).
When retrieving a HydraHeat Pack, it is
important to only lift the divider 2" to 3"
(5-8 cm), just enough to lift the edge of
the pack out of the water. When returning
packs to the tank, flatten first to ensure
smooth operation of the dividers.
NOTE: Lifting dividers further than 3" may
allow packs in the adjacent dividers to slip
out of the divider and into the bottom of
the tank.
Front Rack
3x Universal
Clip
Clip
2x Standard 1x Standard + 1x Cervical 2x Cervical 2x Oversize
1x Oversize
Figure 2. Side View of Tank
Figure 1.
6