Ricoh 1075 - Page 71

Procedure for Sending E-mails
67
6
Calling up stored scan settings
A Press [Recall Program].
The Recall Program screen is
displayed.
B Select a user program of scan
settings.
C Press [OK].
The selected user program set-
tings are applied.
Making the settings individually
A Press [Scan Settings].
The screen for making scan set-
tings is displayed.
B Select resolution, original size,
and other items to change the
corresponding setting.
Scan settings are made in the
same way they are programed.
See p.18 “Setting Scanner Fea-
tures”.
C Press [OK].
The scan settings are applied.
G
GG
G
Select the file type if necessary.
A Press [File Type].
B Select the file type of the file to
be attached to the e-mail from
the displayed types.
The selected file type is dis-
played under File Type.
H
HH
H
Select the destination.
Four methods are available for se-
lecting a destination: selecting it
from the list, by specifying a short
ID number, by directly typing the
e-mail address, or by searching it.
Note
❒ Before selecting the destination,
make sure to select [To]. When
necessary, select [Cc] or [Bcc]
and the respective destinations.
It cannot specify more than 100
destinations including [To], [Cc]
and [Bcc].
When selecting a destination
from the list
A Press the title for the desired
destination. The destinations
for that title are displayed.
If the desired destination is not
displayed, press [U
UU
U] or [T
TT
T] to
display the destination.