Sending Scan Files by Scan to Folder
38
3
M Check the connection test re-
sult, and then press [Exit].
N Press [OK].
O To enter more destinations, re-
peat steps A to N.
Note
❒
To deselect a destination, press
[UPrev.] or [TNext] to display
the destination in the desti-
nation field, and then press
the {Clear/Stop} key.
❒ To change the path for the
folder that has been entered,
press [Change] on the left side
of the destination field. Enter
the correct path for the fold-
er, and then press [OK].
❒ To check the selected desti-
nations, press the {Check
Modes} key.
Directly enter the path for the
folder in the NDS tree or on the
NetWare server
A Press [Enter Destination].
B Press [NCP].
Note
❒ If you try to switch to a pro-
tocol from one for which
[Path], [User Name] or [Pass-
word] is specified, a message
asking you to confirm the
protocol change appears.
C Select "Connection Type". To
specify the NDS tree name,
press [NDS]. To specify the Net-
Ware server name, press [Bind-
ery].
D Press [Manual Input] on the right
side of the path field.
The soft keyboard appears.
E Enter the path for the folder.
Note
❒ If you set "Connection Type"
to [NDS], the NDS tree name
is “tree”, the name of the con-
text including the volume is
“context”, the volume name
is “volume”, and the folder
name is “folder”, the path
will be “\\tree\volume.con-
text\folder”.
❒ If you set "Connection Type"
to [Bindery], the NetWare
server name is “server”, the
volume name is “volume”,
and the folder name is “fold-
er”, the path will be “\\serv-
er\volume\folder”.
❒ For details about the maxi-
mum number of characters
that can be entered, see p.123
“Scan to Folder”.
F Press [OK].
G Enter the user name for log-
ging on to the NDS tree or Net-
Ware server.
Press [Manual Input] to the right
of the user name field.
The soft keyboard appears.
To Next Page
Loading...
