Sending Scan Files by Scan to Folder
39
3
Note
❒ If you press [NDS] for "Con-
nection Type", enter the user
name, and then enter the
name of the context contain-
ing the user object. If the user
name is “user” and the name
of the Context is “context”,
the user name will be “us-
er.context”.
Reference
For details about the maxi-
mum number of characters
that can be entered, see p.123
“Scan to Folder”.
H If a password is required for
logging on, enter it.
Press [Manual Input] to the right
of the password field.
The soft keyboard appears.
I Press [Connection Test].
A connection test checks the
specified shared folder exists.
Note
❒ You cannot connect to fold-
ers you are not allowed to
read.
❒ The connection test may take
time.
❒ You may not be able to press
[Connection Test] right after
pressing [Cancel] during a
connection test.
❒ Even if the connection test
was successful, the machine
may fail to transfer the file if
you do not have write privi-
leges for the file or there is
not enough free hard disk
space.
J Check the connection test re-
sult, and then press [Exit].
K Press [OK].
L To enter more destinations, re-
peat steps A to K.
Note
❒
To deselect a destination, press
[UPrev.] or [TNext] until the
destination appears in the
destination field, and then
press the {Clear/Stop} key.
❒ To change the path for an en-
tered folder, press [Change]
on the left side of the destina-
tion field. Enter the correct
path for the folder, and then
press [OK].
❒ To check the selected desti-
naions, press the {Check-
Modes} key.
Select a folder on a network
computer
A Press [Enter Destination].
B Press [SMB].
Note
❒ If you try to switch to a pro-
tocol from one for which
[Path], [User Name] or [Pass-
word] is specified, a message
asking you to confirm the
protocol change appears.
C Press [Browse Network] on the
right side of the path field.
The list of client computers on
the same network appears.
To Next Page
Loading...
