x Clearing Misfeeds
105
5
x
xx
x
Clearing Misfeeds
CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings are cleared.
❒ To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒ If misfeeds occur repeatedly, contact your service representative.
Note
❒ More than one misfeed location may be indicated. In such a case, check every
applicable area. See the following charts:
• A, B, C, D, E, F ⇒ p.106
• P, Q, R(Finisher 3000M), U ⇒ p.108
• R(Booklet Finisher), W ⇒ p.110
• R(Finisher 3000B) ⇒ p.112
• N(Z-folding unit) ⇒ p.113
❒ You can find a sticker explaining how to remove misfed paper inside the front
cover or finisher.
• The fusing section of this machine might be very hot. Caution should be tak-
en when removing misfed paper.
MartiniC2_ENzen_F_pre_FM.book Page 105 Tuesday, July 27, 2004 1:24 PM
To Next Page
Loading...
Need help?
General
