Troubleshooting
137
8
Troubleshooting
Error & Status Messages on the Display Panel
This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see "Turning On the Power", General Set-
tings Guide.
❖
❖❖
❖ Status messages
❖
❖❖
❖ Alert messages
Message Status
Hex Dump Mode In Hex Dump mode, the machine receives data in hexadecimal
format. Turn off the machine after printing, and then turn back on.
Offline The machine is offline. To start printing, switch the machine
online by pressing
[Offline]
on the display panel.
Please wait. The machine is preparing the development unit. Wait a while.
Printing... The machine is printing. Wait a while.
Ready This is the default ready message. The machine is ready for
use. No action is required.
Resetting job... The machine is resetting the print job. Wait until “Ready” ap-
pears on the display panel.
Setting change... The machine is setting changing. Wait a while.
Waiting... The machine is waiting for the next data to print. Wait a while.
Messages/Second messages Causes Solutions
Authentication has failed. The login user name or pass-
word entered is incorrect.
The machine currently cannot
perform authentication.
Check your login user name
and password.
Consult an administrator.
Cannot connect with the
wireless card.
The IEEE 802.11b interface
unit may have come off, or an
error may have occurred in the
IEEE 802.11b interface unit.
Turn off the main power
switch, and check the IEEE
802.11b interface unit is in-
stalled correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Collate has been cancelled. The collate print function has
been canceled.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
MartiniC25-EN-Pref-F_FM_ZF.book Page 137 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
Need help?
General
