DRAFT 2003/11/12
Copying
26
2
Note
❒ To change the value entered,
press the {
{{
{Clear/Stop}
}}
} key, and
then enter the new value.
❒ The entered copy size should be
280 mm (11") or more.
❒ The maximum length of copy
sizes is as follows:
• HDD not installed:
Y1 + Y2 ≤ 1189 mm (48")
• HDD installed:
Y1 + Y2 ≤ 3600 mm (142")
❒ If the length specified by “Y1”
and “Y2” is longer than the
maximum, the machine short-
ens it. The value entered second
is adjusted based on the value
entered first.
E
EE
E
Press [Exit].
F
FF
F
Make the necessary settings.
G
GG
G
Place your originals.
The machine copies the specified
area.
Exiting partial copy
A Press the {
{{
{Clear Modes}
}}
} key.
Copying from the Bypass Tray
Use the bypass tray to copy onto pa-
per sizes that cannot be loaded on the
paper rolls, or cut sheet paper.
Limitation
❒ You cannot use Interrupt Copy af-
ter setting the original.
❒ The maximum length is 2000 mm
(78").
❒ The width for paper in the bypass
tray is 210 – 914 mm (8
1
/
2
" – 36").
❒ Insert the paper in the bypass tray
lengthwise or sideways to fit it
onto the feeding orientation.
❒ Insert the paper in the bypass tray
lengthwise when you use A0(E)
size paper.
❒ Do not copy on both sides of the
paper.
❒ Do not use paper already copied or
printed on.
❒ You cannot use Job Preset. If you
scan several originals, the last is
used.
Reference
For details about paper type, ori-
entation, and number of sheets
that can be loaded in the bypass
tray, see “Copy Paper” General Set-
tings Guide.
A
AA
A
Select [Bypass] using the 0
00
01
11
1
keys.
[Bypass] is highlighted.
B
BB
B
Make the necessary settings.
C
CC
C
Place your original and scan it.
Reference
p.16 “Placing Originals”
To Next Page
Loading...
