DRAFT 2003/11/12
Basic Procedure
27
2
D
DD
D
Adjust the bypass tray's paper
guides to the size of the paper.
E
EE
E
Insert the paper in the bypass
tray, copy side up.
The paper feeds in automatically
and copying starts.
Important
❒ Insert the paper evenly on both
sides and support it with your
hands until it feeds in.
Note
❒ To make multiple copies, insert
an additional sheet after each
feeds in.
❒ To set a rolled original, pull out
the lower output auxiliary
guide to the front, and then
place the rolled original on it.
See p.18 “Setting Rolled Origi-
nals”.
Programs
You can store frequently used copy
job settings in machine memory, and
recall them for later use.
The Program function includes the
following settings:
❖
❖❖
❖ Storing a program
To store frequently used settings.
❖
❖❖
❖ Deleting a program
To delete a stored program.
❖
❖❖
❖ Recalling a program
To recall a stored program.
Note
❒ You can store up to 10 programs.
❒ You can only select the paper tray.
You cannot store a paper type or
size.
❒ If you store the settings in the pro-
gram sheet, you can create a list.
See p.114 “Program Record Sheet”.
❒ Immediately after the machine is
turned on, after Copier Auto Reset,
or after the {
{{
{Clear Modes}
}}
} key is
pressed, settings are reset to stand-
ard or those stored in program No.
10. See p.84 “Change Init. Mode”.
❒ Stored settings are kept even after
the power is turned off or the
{
{{
{Clear Modes}
}}
} key is pressed. They
are cleared only when you delete
or edit them.
AAJ512D
AAJ513S
To Next Page
Loading...
