DRAFT 2003/11/12
Copying
48
2
Note
❒ The area is specified by defining
two points for the top left of the
original (X1, Y1) and two points for
the size of the area (X2, Y2). Meas-
ure the area you want to specify
before entering the area settings.
❒ When using this function with
magnification, the actual setting
will be the specified setting multi-
plied by the reproduction ratio.
❒ You can specify up to five areas.
A
AA
A
Press the {
{{
{Shift/Erase}
}}
} key.
B
BB
B
Display “Shift/Erase 2/2” using
the 1
11
1 key, and then press
[E.Outsd.].
C
CC
C
Press [Area 1].
D
DD
D
Enter the length of “X1” using the
number keys, and then press the
{
{{
{#}
}}
} key.
E
EE
E
Enter the length of “X2”, “Y1”,
and “Y2” in the same way, and
then press [OK].
Note
❒ To change a length, select the
length you want to change us-
ing the 01 keys, and then en-
ter the new length.
F
FF
F
To specify multiple areas, specify
areas 1 to 5, and then repeat steps
D
DD
D
to
E
EE
E
.
Note
❒ To display [Area 4] and [Area 5],
press the 01 keys.
G
GG
G
Press [Exit] twice.
ABB525S
Area
ABB557S
To Next Page
Loading...
