Placing Originals
18
1
E Enter the vertical size of the original (Vert.) with the number keys, and then
press the {OK} key.
The “
Programmed” message appears.
When the custom size originals settings are registered, appears
on the top of the copy display.
Note
❒ This function is not available in Auto Paper Select mode.
❒ If you make a mistake in step
D
or
E
, press the {Clear/Stop} key, and then
enter the value again.
❒ To cancel the size you have set, press the {Clear Modes} key.
Specifying the Original Size When the Bypass Tray is Selected
You can select either regular or custom for the size of the original when the by-
pass tray is selected.
Regular sizes
When placing regular size originals on the exposure glass, or in the ADF or AR-
DF, select the size of the originals from the regular sizes shown on the display.
A Select [Bypass] using {U} or {T}.
B Press the {q} key.
To Next Page
Loading...
